CM 5/16″ Nominal Chain Size, 0.75 Ton Carbon Steel Round Anchor Shackle 15/32″ Diam, 3/8″ Pin Diam, 17/32″ Wide Inside Jaw, 25/32″ Inside Width

Manufacturer Part #: MC347G

S/N: 64618366

UNSPSC: 31162800

(Minimum Order Quantity=1, Package Quantity=1)

Specifications:

GS Tooling CAT50 25mm x 100mm Shrink Fit Holder w/ Coolant Ports – 541-924

• Unsurpassed Accuracy: Concentricity of .0001 (3m) with tool shrunk in holder.
• Coolant Ports: Each holder has 4 coolant ports in the nose to ensure coolant gets right to the tool.
• Max Gripping Torque: Tool is gripped 360 along the entire length of bore producing very high gripping torque, preventing chatter.
• Increased Production: Decrease down time – the total time elapsed to remove one cutting tool and insert another is less than 10 seconds.
• Balanced: GS follows the strictest balance standards. Our holders are pre-balanced G2.5 up to 30,000rpm
• Extended Holder Life: With double tempered tool steel construction, reduced centrifugal forces, minimized bore contamination, and minimized chatter, a GS Shrink Fit Toolholder should far outlast a standard end mill holder.
• Chip load distributed evenly along cutting edge of tool which results in longer tool life
• Short projections are possible because no mechanical clamping devices are used. This results in greater rigidity and resistance to bending.
• Since Shrink Fit toolholders have no moving parts they offer the greatest repeatability of any tool holding system on the market.

For More GS Tooling CAT50 Metric Shrink Fit Holder w/ Coolant PortsClick Here